2265 examples of fouling in sentences

The British administration would not be parties to the perpetuation of a system which permitted the fouling of good crystal water.

The fouling of the blank cartridge is as dangerous to the bore as the fouling of the ball cartridge.

The fouling of the blank cartridge is as dangerous to the bore as the fouling of the ball cartridge.

Briefly stated, the care of the bore consists in removing the fouling, resulting from firing, to obtain a chemically clean surface, and in coating this surface with a film of oil to prevent rusting.

The fouling which results from firing is of two kindsone, the products of combustion of the powder; the other, cupro-nickel scraped off (under the abrading action of irregularities or grit in the bore).

Powder fouling, because of its acid reaction, is highly corrosive; that is, it will induce rust and must be removed.

Metal fouling of itself is inactive, but may cover powder fouling and prevent the action of cleaning agents until removed, and when accumulated in noticeable quantities it reduces the accuracy of the rifle.

Metal fouling of itself is inactive, but may cover powder fouling and prevent the action of cleaning agents until removed, and when accumulated in noticeable quantities it reduces the accuracy of the rifle.

(b) Powder fouling may be readily removed by scrubbing with hot soda solution, but this solution has no effect on the metal fouling of cupro-nickel.

It is necessary, therefore, to remove all metal fouling before assurance can be had that all powder fouling, has been removed and that the bore may be safely oiled.

Normally, after firing a barrel in good condition the metal fouling is so slight as to be hardly perceptible.

However, due to pitting, the presence of dust, other abrasives, or to accumulation, metal fouling may occur in clearly visible flakes or patches of much greater thickness, much more difficult to remove. (c) In cleaning the bore after firing it is well to proceed as follows: Swab out the bore with soda solution (subparagraph j) to remove powder fouling.

However, due to pitting, the presence of dust, other abrasives, or to accumulation, metal fouling may occur in clearly visible flakes or patches of much greater thickness, much more difficult to remove. (c) In cleaning the bore after firing it is well to proceed as follows: Swab out the bore with soda solution (subparagraph j) to remove powder fouling.

Examine the bore to see that there are in evidence no patches of metal fouling which, if present, can be readily detected by the naked eye, then swab out with the swabbing solutiona dilute metal-fouling solution (subparagraph j).

Examine the bore to see that there are in evidence no patches of metal fouling which, if present, can be readily detected by the naked eye, then swab out with the swabbing solutiona dilute metal-fouling solution (subparagraph j).

(e) If patches of metal fouling are seen upon visual inspection of the bore the standard metal fouling solution prepared as hereinafter prescribed must be used.

With few exceptions, one application is sufficient, but if all fouling is not removed, as determined by careful visual inspection of the bore and of the wiping patches, repeat as described above.

(g) If the swabbing solution or the standard metal-fouling solution is not available, the barrel should be scrubbed, as already described, with the soda solution, dried, and oiled with a light oil.

At the end of 24 hours it should again be cleaned, when it will usually be found to have "sweated"; that is, rust having formed under the smear of metal fouling where powder fouling was present, the surface is puffed up.

At the end of 24 hours it should again be cleaned, when it will usually be found to have "sweated"; that is, rust having formed under the smear of metal fouling where powder fouling was present, the surface is puffed up.

If the bore is not clean when oiledthat is, if powder fouling is present or rust has starteda half inch of cosmic on the outside will not stop its action, and the barrel will be ruined.

The first application of soda solution removes the greater portion of the powder fouling and permits a more effective and economical use of the ammonia solution.

The fouling is easier to remove then, and if left longer it will corrode the barrel.

SEE Anti-fouling boat bottom paint.

The object of the Mauser and Remington system in covering the bullets, the one with nickel and the other with brass, is not to poison, but to prevent the lead from fouling the rifles.

2265 examples of  fouling  in sentences